Apply Joint Compound
to Smooth Out Walls
Joint compound is a type of plaster that's used to finish off the seams between sheets of drywall during construction. Applied correctly, it renders the seams between individual sheets invisible once painted. Joints must be covered in drywall tape in order to give the joint compound something to adhere to so that the compound can be applied smoothly.
Instructions
1. Run your hand along the surface to feel for raised screw heads left sticking out from the wall during construction. Sink any protruding screw heads with a screw gun so that the heads are flush with the surface of the wall.
2. Press drywall tape over each seam between sheets of drywall, ripping off any excess tape at the top and bottom of each seam.
3. Spread joint compound over the seams, using a drywall knife to completely cover the tape. Make the line of joint compound 4 inches wide, or 2 inches wide on either side of the seam, and completely flat. Spread a dab of joint compound flat over each screw hole as well.
4. Wait at least six hours, or overnight, for the joint compound to dry. Run the long edge of the drywall knife over the dried compound to knock off any lumps.
5. Spread a second coat of joint compound on top of the first in a seam 6 inches wide, so it completely covers the first seam. Let the compound dry for at least six hours. Scrape the area with your drywall knife again to remove any additional lumps.
6. Spread on a third and final coat of joint compound in a seam 8 inches wide -- an inch wider on either side of the seam than the previous application. Let it dry at least six hours or overnight.
7. Sand the seams very lightly with a sanding pad to make them flat and even. Use a broom to brush dust off the wall's surface.
Related posts
Creating perfect sheetrock joints takes patience and practice.Sheetrock is a name brand for drywall that is common enough to be almost a synonym in some regions. It is made up of a layer of crushe...
Drywall sheets are sealed together with tape (either paper or mesh) and joint compound, which is a form of plaster. The compound is laid over the tape in three layers, each one successively wider...
Apply joint compound with a drywall knife.Painting over newly applied joint compound isn't difficult, but unless you follow the proper procedure, you may end up with a bumpy wall surface, flat spo...
Taping out corners requires a slightly different technique.Drywall panels give your walls a smooth look, suitable for painting or for hanging wallpaper. During installation, the panels are cut and...
After installing drywall, this worker should feather the joint compound to disguise the seams.Feathering joint compound refers to spreading compound over the seams of drywall. After drywall has be...
