Refinishing plaster restores the original look of a wall.
Plaster is a cement finish used to cover walls. Before the advent of gypsum and Portland cement, plaster was made of lime and sand. Plaster and stucco are composed of the same material, so in essence they are the same thing; plaster is the term given to interior applications, and stucco refers to the lime and sand mix when used for exterior projects. Regardless, plaster refinishing -- both interior and exterior jobs -- can be accomplished with a few materials and some simple tools.
Instructions
1. Clean away the broken and cracked plaster on your wall with the putty knife. Slide the putty knife between the plaster and the wood framing and scrape off the damaged portions. The plaster will break off easily. Once you have cleaned away all the damaged plaster, apply shellac to the wood framing with a paintbrush. The lime in the mortar will eat away at the wood if you do not do so. Apply a thick, heavy coat. Allow the shellac to dry.
2. Fill a 100-ml beaker with sand. Fill the beaker with alcohol at 10-ml intervals. When the sand is completely saturated, total the number of milliliters of alcohol it required to saturate the sand. Divide that number by 10. That number represents sand in your lime-to-sand ratio. The lime number is always one. For example, if it required two 10-ml beakers to saturate your sand, your ratio is 1 part lime, 2 parts sand.
3. Alternate pouring sand and lime into the mixer at the ratio you determined. Allow the mortar to combine for 15 minutes. Do not add water unless the mortar crumbles and is flaky, and then, only at 8 ounces per 15 gallons of mortar. Keep the mortar away from heat and sunlight as you are mixing it. If you cannot avoid one or the other, add subtle amounts of water. Mix the mortar for at least 20 minutes.
4. Dump some mortar in your 5-gallon bucket. Allow the remaining mortar to continue mixing. With your trowel, apply the mortar to the damaged area. Dip your trowel in the bucket, scoop out a little mortar and fling it onto the wall. With with sweeping strokes, spread the mortar thin. If you plan to add a second or third coat, make sure your original coat is thinner than the undamaged area around which you are troweling your mortar. Allow your first coat to dry before adding a second.
Related posts
A lot of people have that one (or more) unsightly brick wall they just don't know what to do with. Maybe it's an interior wall, the one behind a fireplace, or a brick wall separating your house fr...
Plaster walls create texture, depth and timeless elegance in a room. Although it is not used in new buildings, plaster still is an effective way to cover a wall. Plaster is ideal in additions on o...
Repair Hairline Cracks in PlasterHairline cracks in plaster can indicate an overall structural problem that should be addressed. However, if the cracks are merely cosmetic, they can be repaired. U...
A plastered ceiling in the works.Applying plaster on a ceiling can be a messy endeavor, however, virtually anyone can complete the task. Depending on your desired look, there are many ways in whic...
Fill in a hole in plaster board.Wallboard, or plaster board, is the most common building material for walls today. The benefits of plaster board over traditional plaster are many. It is cheaper, e...
