Creating perfect sheetrock joints takes patience and practice.
Sheetrock is a name brand for drywall that is common enough to be almost a synonym in some regions. It is made up of a layer of crushed gypsum, sandwiched between two layers of paper to create a rigid wall board that can be attached with nails or screws directly to the interior frame of your structure. The seams between panels are then filled with a wet clay-like mortar, known as joint compound, or drywall mud. The sheets are tapered at their adjoining edges to make invisible seams possible.
Instructions
1. Fill a drywall mud trough with compound. Scoop compound onto the blade of an 8- to 10-inch wide drywall finishing knife, also known as a drywall trowel. Fill the valley created by the tapered edges along the two sheets of drywall where they meet, starting at the top of the wall. Press the compound into the seam and drag the knife over the top of it, with the blade perpendicular to the seam, to smooth it.
2. Continue adding and smoothing compound until you reach the the bottom of the seam. Fill the seam in the same way, working side to side for horizontal seams. Roll out enough paper drywall joint tape to cover the length of the seam and cut it off with a utility knife.
3. Start at the top, or one end of your seam and press the tape into the wet compound with the folded edge in the center of the tape facing down. Drag the drywall knife over the tape to smooth it with the blade perpendicular to the seam and leaning slightly in the direction of the stroke.
4. Add a small amount of compound on top of the tape with the knife, smoothing it as you go. Watch for ripples in the paper tape. Have a helper hold the top end, or one end if working a horizontal seam, firmly against the wall, and smooth the entire piece back into place if needed to release wrinkles.
5. Allow the compound to dry until it all has a white chalky appearance. Add a third thin coat, called the top, or topping coat, of compound over the taped area, using the wide knife to blend the edges into the panels on either side. Keep the goal in mind of raising this area just slightly so that it can be sanded down to perfectly meet the panels on either side.
6. Allow the compound to dry thoroughly. Sand the seam smooth with a drywall sanding screen on an extension pole. Use a fine grit screen for best results.
Related posts
Joint compound is used to hide drywall seams.Covering a ceiling takes multiple drywall sheets. Some of the sheets are cut to fit smaller areas. A seam forms where each drywall sheet touches anothe...
Apply Joint Compound to Smooth Out WallsJoint compound is a type of plaster that's used to finish off the seams between sheets of drywall during construction. Applied correctly, it renders the sea...
Drywall sheets are sealed together with tape (either paper or mesh) and joint compound, which is a form of plaster. The compound is laid over the tape in three layers, each one successively wider...
After installing drywall, this worker should feather the joint compound to disguise the seams.Feathering joint compound refers to spreading compound over the seams of drywall. After drywall has be...
Taping out corners requires a slightly different technique.Drywall panels give your walls a smooth look, suitable for painting or for hanging wallpaper. During installation, the panels are cut and...
