Wet drywall can be very hazardous to your health. Several types of mold will begin to grow and expand as long as the drywall remains wet. Fixing wet drywall requires removing moisture from the area. All existing mold and contaminated debris also will have to be removed. The area will need to be disinfected, sanitized, cleaned and deodorized before the repair can be completed.
Instructions
1. Determine the source of the moisture that is contaminating the drywall. Eliminate the possibility of moisture returning to the area.
2. Cut a line with the utility knife around the wet area. Extend the line 2 feet past the wet drywall. Do not try to cut all the way through the drywall with the utility knife. Just cut enough of the top layer to mark the area. Use a drywall saw to cut through and around the marked area. Use a hammer to remove the cut drywall. Wear a good quality face mask respirator to protect your lungs from the airborne mold spores and dust created by the removal.
3. Spray the area with a disinfectant designed for use on surfaces susceptible to microbial contamination.
4. Place circulating air fans and/or dehumidifiers near the area to completely remove all moisture. This can take up to three days in severely flooded situations. An air conditioner can take longer if used by itself to dry the area. All wood studs, concrete and other surfaces must be completely dry before replacing the drywall.
5. Cut new drywall to fit the hole. Use a screwdriver or drill to fasten the drywall to studs with drywall screws. Spread drywall joint compound over the seams, apply drywall tape and allow to dry. Add additional coats of joint compound to smooth the area and feather the edges. Sand each coat of joint compound after it dries, and paint as desired.
Related posts
Wallpaper liner is notoriously difficult to remove from drywall. It often rips the paper surface of the drywall, causing damage that must be repaired. This process is not difficult, but it is labo...
New walls may crack as wall studs and ceiling trusses dry.Shrinkage cracks are common in drywall, especially in wood-frame homes. These cracks tend to appear as the lumber loses its moisture conte...
Joint compound and a putty knife are used to patch holes in drywall.A hole in your wall might look like a disaster, but it is not. Most walls are made of drywall, also called wallboard and gypsum...
Standard wall studs are 16 inches apart. Find the studs near your damaged drywall to repair it.Drywall provides a smooth, fire-resistant wall surface. However, drywall panels, composed of pressed...
For large areas of damage, replace the entire drywall panel.Walls made from drywall panels are standard in residential and commercial construction projects, but exposure to moisture, an impact or...
