It's fairly easy to patch small holes in drywall.
Drywall is a building material that consists of gypsum plaster pressed between two thick sheets of paper. It is used in construction to create walls and ceilings by screwing the drywall sheets to the ceiling joists and wall studs. During construction, insulation is usually installed before the drywall, but in some cases, such as a garage, it may not be. In instances like this, you can add loose-fill insulation by cutting small holes in the drywall and blowing the insulation behind the drywall sheet. After you finish installing the insulation, you must patch the hole.
Instructions
1. Measure the height of the hole and cut a piece of 1-inch by 3-inch wood strapping that is 6 inches longer than the height of the hole.
2. Apply a thick bead of construction adhesive to the front of the wood strapping.
3. Carefully slide the strapping into the hole with the adhesive side facing you. Pull the strapping towards you, and drill two screws into the top and bottom edges of the board through the drywall. Stagger the screws, and drive them deep enough so that they're just below the surface of the drywall.
4. Measure the size of the hole and cut a patch to fit out of a scrap piece of drywall with a utility knife.
5. Press the drywall patch firmly against the strapping and drill two staggered screws through the drywall patch and into the strapping, driving the heads just beneath the surface of the drywall.
6. Apply a thin layer of joint compound over the drywall patch, the screwheads and the seams along the patch with a 6-inch taping knife.
7. Press a piece of window screen a few inches larger than the patch into the joint compound with the taping knife.
8. Place more joint compound over the screen. Work out from the center of the screen to the edges so you don't wrinkle the screen, and wipe away any excess joint compound with the trowel. Allow the joint compound to dry overnight.
9. Apply another thin layer of joint compound over the patch, this time with a 12-inch taping knife. Allow the joint compound to dry.
10. Sand the patched area with a fine silicon-carbide sandpaper. Sand just enough to smooth the surface of the patch; you don't want to sand deep enough to expose the screen.
11. Wipe the dust off the wall with a dry rag.
12. Add a coat of primer to the patch, then paint over it to match the rest of the wall.
Related posts
Joint compound and a putty knife are used to patch holes in drywall.A hole in your wall might look like a disaster, but it is not. Most walls are made of drywall, also called wallboard and gypsum...
Repair damaged drywall around a window.Drywall panels, made from tightly compressed gypsum particles and covered with thick paper, offer a smooth interior wall surface. Unfortunately, drywall is r...
Medium-sized Hole in DrywallDrywall can be damaged in any number of ways. From door handles to an exciting game of indoor football, the result is the same. Though the hole sizes will vary greatly,...
Drywall repair professionals can fix cracks and holes in drywall.After drywall has been installed, a number of problems may arise over time. Temperature fluctuations in home temperature can cause...
Repairing drywall requires patience and attention to detail.Small holes develop in drywall for a variety of reasons. The drywall directly behind a door is a common area for damage from doorknobs....
