Repair hairline cracks in drywall.
Even imperceptible shifting of a house foundation may result in small hairline cracks in the drywall. The most common areas for cracks are above the corners of doors, above and below installed windows and in the corners of a room, near the ceiling. When cracks occur, you can repair them by applying drywall mud, letting it dry and then sanding the area before repainting. The use of mesh drywall tape may help the area resist further cracking.
Instructions
1. Prepare the area by removing nearby wall hangings and by draping the floor with a heavy tarp to prevent damage to the carpet or the flooring.
2. Stir the premixed drywall mud to smooth out any thickened areas, and scoop out a small amount into your drywall tray. A drywall tray is narrow and oblong to hold the mud while providing a smooth edge on which to scrape excess mud from your trowel.
3. Apply a scoop of drywall mud to the hairline crack with the 6-inch taping knife, smoothing the mud into the crack by using pressure as you run the knife from the top of the crack to the bottom. Fill the crack entirely, and use the knife to remove excess drywall mud from the edges of the crack.
4. Cut a strip of mesh drywall tape approximately 2 inches shorter than the crack, and press it onto the crack while the drywall mud beneath is still damp. Smooth out the tape to eliminate any wrinkles.
5. Scoop up some fresh drywall, mud and apply it evenly over the mesh tape, using gentle pressure to push the mud into the small holes.
6. Switch to the 12-inch taping trowel, and gently smooth the mud along the tape. This wider taping knife pushes the edge of the mud outwards to reduce the appearance of a bulge over the tape. Remove any excess, and allow the wall to dry completely.
7. Repeat the application of drywall mud with the 12-inch trowel, adding a little more to the taped cracks and smoothing them out as flat as possible. Drywall mud shrinks slightly as it dries, so two more very thin coats will add strength without creating a bulge.
8. Sand the wall with a drywall-sanding pad after the last coat of mud is dry. Use light, even sanding strokes. Run your hand over the repaired seam to check for rough spots. After repainting, any mistakes will become very apparent, so now is the time to make sure the wall is as smooth as you can make it.
Related posts
Drywall damage is fixed easily, though it takes time to dryWhen a seam or crack in drywall appears, it usually means that either the house has shifted a little over time or that a dry climate has...
Cracks may appear above doors.It's not uncommon to find cracks in drywall above doors or above and below windows, because in these areas, the wall structure is slightly weaker. When the contractor...
Drywall sheets are sealed together with tape (either paper or mesh) and joint compound, which is a form of plaster. The compound is laid over the tape in three layers, each one successively wider...
Repair a Drywall CrackDrywall cracks can occur for any number of reasons. Over the years homes begin to settle sometimes causing cracks around the corners of doors and windows or where columns sup...
New walls may crack as wall studs and ceiling trusses dry.Shrinkage cracks are common in drywall, especially in wood-frame homes. These cracks tend to appear as the lumber loses its moisture conte...
