Tape Wallboard Joints
Is it time to finish those drywall seams? Transitioning your drywall can be one of the most frustrating aspects of installing drywall. Here is a step by step guide on tape drywall joints.
Instructions
1. Measure and cut the lengths of paper joint tape required for each joint. Measurements don't have to be exact as you can make adjustments later.
2. Soak the strips of paper joint tape in water for 5 minutes. If you aren't able to completely submerge the strips, run them under water or wet them with a spray bottle. This is an extremely important step that will prevent the tape from bubbling up later.
3. Using a wide tape knife, apply a layer of joint compound evenly along the joint.
4. While the joint compound is still wet, press the paper wallboard tape into the joint compound. The crack should be in the middle of the tape. After all of your tape is in place, let it dry overnight.
5. Apply a second thin coat of joint compound to the joint. Allow the compound to harden completely before proceeding to the next step.
6. Sand the joint with a fine grit sand paper until you achieve a smooth surface. If you are left with any indentions, repeat step #5.
Related posts
Drywall joints are finished by filling the space between the individual sheets with a joint compound. To strengthen and prevent it from cracking, paper or fiberglass tape is added to the joint.Whe...
Install tile on taped and sanded wallboard.Tile adds a design element to your walls, but before you install it, you must prepare unfinished wallboards to ensure that the tile lays flat. Wallboards...
Joint compound and drywall tape make wall seams invisible.Drywall panels give interior walls a smooth, professional look. Made from tightly compressed gypsum particles and covered with thick paper...
Dips and ridges in your drywall tape are not usually visible until after the walls are primed.Drywall tape conceals the joints of hung drywall. Yet when drywall tape is not put on correctly, it ca...
Mudding is the process of applying wet joint compound to the seams between drywall panels and smoothing it flush with the wall. In almost all cases, you need to apply drywall tape to the seams to...
