Save money by removing drywall yourself.
Both homeowners and contractors choose drywall to cover unfinished masonry walls when turning a basement into a livable space. Drywall is a gypsum-core paper covered building material. Hanging drywall over masonry walls consists of nailing the drywall sheets into furring strips. Furring strips are thin pieces of wood, hung on masonry surfaces that create a strong and stable gripping surface for drywall. Removing drywall becomes necessary to gain access to the masonry surface behind the drywall or because of damage such as large holes, cracks and water damage. Drywall acts as wick, draws water up and spreads it throughout the sheet. Wet drywall causes an unstable wall and a perfect breeding ground for mold and mildew growth.
Instructions
1. Turn the electrical power off in the basement and set up shop lights.
2. Strike the drywall forcefully with the claw end of a hammer to create a hole. Work carefully in areas directly up and down from light switches and receptacles where wires may run. Typically, no plumbing pipes run behind drywall because there is not enough room so they are not a concern when choosing a starting point.
3. Place a pry bar into the hole and wedge it between the drywall and the masonry surface.
4. Pull the pry bar to break the drywall and loosen it from the furring strips. The furring strips may come away from the masonry surface while you are prying the drywall off the walls.
5. Move the pry bar as pieces break off, wedge it under the drywall and pry again until you expose the cinder block walls.
Related posts
You can install drywall over cinder block.Drywall panels, made from compressed gypsum, offer a smooth surface when used to construct walls. While drywall is typically installed on framed wood wall...
An old masonry wall can be covered with furring strips and drywall.A concrete block wall in your home or basement may not coordinate with the design style you are attempting to achieve. One of the...
Install drywall on interior cement blocks.Cement blocks provide structural integrity and are common in basement construction, but they're also cold, sometimes damp, and aren't aesthetically pleasi...
Finishing the drywall requires hiding the seams with drywall compound and tape.Erecting walls is the process of placing a finishing material onto a subsurface. Frame houses use 2-by-6 wood beams a...
Drywall is usually fastened to the wall studs with drywall screws. But with walls constructed of block, the drywall cannot be fastened directly to the walls. Furring strips must first be attached...
